ZAMST ZW-5 Instrucciones De Uso página 2

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 5
How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• These steps show how to attach ZW-7. Use the same steps to attach ZW-5.
1.
Unfasten all the hook-and-loop fasteners of the product.
Confirm the top/bottom, inside/outside, and front/back of
the product.
Auxiliary belt
<Outside of the product>
Hook-and-loop
fastener on the
auxiliary belt
Tag
Hook-and-
<Inside of the product>
loop fastener
on the support
2.
Attach the product to your lower back.
ZW-5
3D back
panel
<Back view>
Attach the product so that the center of the 3D back panel in the
middle of the product is aligned with your spine.
ZW-7
3D back
panel
<Back view>
Attach the product so that the center of the 3D back panel in the
middle of the product is aligned with your spine.
3.
Wrap the product around the lower back and fasten the
hook-and-loop fastener on it in front of the body.
Hook-and-loop fastener
on the support
Fasten the hook-and-loop fastener on the product in front of the body
by pulling both ends of the product. Make sure the top edge of the
product is below the navel.
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Ensure the size tag
on the inside of the
product is at the top
when attaching the
product to your back.
Spine
line
Spine
line
Navel
4.
Fasten the auxiliary belt to the product.
Hook-and-loop
fastener on the
auxiliary belt
Hold both ends of the auxiliary belt with both hands, pull them
simultaneously until appropriate tension is created, then fasten them
to the abdomen.
5.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
The product correctly fastened
ZW-5
<Front view>
<Back view>
ZW-7
<Front view>
<Side view>
<Side view>
<Back view>
Hook-and-
loop fastener
on the
auxiliary belt

Publicidad

Tabla de contenido
loading

Productos relacionados para ZAMST ZW-5

Este manual también es adecuado para:

Zw-7

Tabla de contenido