Hardware Installation - Air Live MW-2000S Manual Del Usuario

Hardware installation

Connect the DC power adapter to the power connector socket on
1.
the rear panel. The Power LED should be on to indicate a proper
connection.
2. Connect an Ethernet cable to the WAN Port on the rear panel.
Connect the other end of the Ethernet cable to ADSL modem, cable
modem or a switch/hub of the internal network. The LED of this
WAN port should be on to indicate a proper connection.
3. Connect an Ethernet cable to Private Port on the rear panel.
Connect the other end of the Ethernet cable to a client's PC. The
LED of Private Port should be on to indicate a proper connection.
(Note: No authentication is required for the users to access the
network via Private Port and the administrator can enter the
administrative user interface to perform configurations via Private
Port.)
4. Connect an Ethernet cable to the LAN1~LAN4 Port on the rear
panel. Connect the other end of the Ethernet cable to an AP or
switch. The LED of LAN1~LAN4 should be on to indicate a proper
connection. (Note: Authentication is required for the users to access
the network via these LAN Ports.)
Wireless Management
Gateway MW-2000S
3
4
2 1
English
3
3