Before Initial Use; Assembling The Device; Basic Accessories - N8WERK MG419H Manual De Instrucciones

NOTICE – RISK OF DAMAGE TO
MATERIAL AND PROPERTY
■ Only connect the device to a plug socket
that is properly installed. The plug socket
must also be readily accessible after
connection so that the connection to the
mains can quickly be isolated. The mains
voltage must match the technical data of
the device.
■ Use only original accessories from the
manufacturer in order to guarantee that
there is no interference that may prevent
the device from working and to avoid
possible damage.
■ Do not operate the device for a long
period of time without any contents to
prevent overheating.
■ Switch off the device and pull the mains
plug out of the plug socket if an error
occurs during operation or before a
thunderstorm.
■ Always pull the mains plug and never the
mains cable to disconnect the device
from the mains power.
■ Do not carry or pull the device by the
connecting cable.
■ Lay the connecting cable in such a way
that it does not become squashed or
bent and does not come into contact
with hot surfaces.
■ Protect the device from heat, naked
flames, direct sunlight, extreme tempera-
tures, moisture and impacts.
■ Store the device in a dry place at temper-
atures of between 0 and 40°C out of the
reach of children and animals.
■ Do not lay or place any heavy objects on
the device or the connecting cable.
16

BEFORE INITIAL USE

There may still be some production residues
on the device. To avoid harmful effects to
your health, clean all accessories thoroughly
before you first use them (see "Cleaning and
Storage").

ASSEMBLING THE DEVICE

Please Note!
■ Pull the mains plug from the plug socket
before swapping inserts to prevent the
device from being switched on acciden-
tally!

BASIC ACCESSORIES

The following basic accessories are required
for processing meat and fish, and making
small sausages, kebbe, and shortbread
shapes:
• Motor unit (15)
• Mincing attachment (9)
• Screw conveyor (6)
• Storage bowl (8)
1. Place the motor unit on a kitchen unit or
another dry, flat and stable surface.
2. Insert the mincing attachment into the
mount (24) of the motor unit as follows:
○ Plug the mincing attachment into the
mount so that the feed chute (21) is at
an angle of 45 ° to the release but-
ton (22) (Picture D), press the release
button if necessary and
○ twist the feed chute upwards until it is
vertical and engages (Picture E).
3. Place the screw conveyor with the long,
narrow end first through the mincing
attachment into the mount (Picture F).
4. Mount the accessory that is required for
the processing you want (see below).
5. Place the storage bowl onto the feed
chute of the mincing attachment.