Dismantling; Cleaning And Storage - N8WERK MG419H Manual De Instrucciones

6. Divide the hollow strand into pieces of
around 8 cm in length.
7. Press down the strand pieces on one
side to seal them. Pour some of the pre-
pared and cooled filling into the pouch
and then seal the other side of the pouch
as well (Picture N).
8. Fry the filled pouches in hot oil until they
are golden brown.
MAKING SHORTBREAD SHAPES
1. Prepare the shortbread mixture accord-
ing to your preferred recipe.
2. Assemble the device in the manner
described in "Assembling the Device"
– "Basic Accessories" and "Shortbread
Attachment".
3. Switch on the device.
4. Place the shortbread mixture into the
feed chute. Slide the mixture down the
feed chute bit by bit using the plung-
er (7).
5. Switch off the device and pull the mains
plug out of the plug socket.
CHOPPING UP VEGETABLES
1. Assemble the device (see "Assembling
the Device" – "Chef's Slicer Attachment").
2. Place a bowl beneath the chef's slicer
attachment to capture the chopped-up
food.
3. Switch on the device.
4. Place the food in the feed chute and
push it through bit by bit using the chef's
slicer plunger (14) (Picture C).
5. Switch off the device and pull the mains
plug out of the plug socket.
20

DISMANTLING

MINCING ATTACHMENT
1. Remove the storage bowl (8).
2. Undo the locking nut (1).
3. Remove the used insert with a screwdriv-
er or something similar (Picture O) and if
applicable the cutter head (5).
4. Take out the screw conveyor (6).
5. Remove the mincing attachment (9)
from the motor unit (15) by pressing the
release button (22) and turning the minc-
ing attachment to the right and pulling it
out at the same time.
CHEF'S SLICER ATTACHMENT
1. Pull the used vegetable slicing insert (10,
11 or 12) out of the chef's slicer attach-
ment (13).
2. Remove the chef's slicer attachment
from the motor unit (15) by pressing the
release button (22) and turning the chef's
slicer attachment to the right and pulling
it out at the same time.

CLEANING AND STORAGE

Please Note!
■ The motor unit, storage bowl, locking nut,
screw conveyor and mincing attachment
are not dishwasher-safe!
■ Do not use any caustic or abrasive clean-
ing agents to clean the device. These
may damage the surface.
1. Dismantle the device in the reverse order
(see "Dismantling").
2. Remove any possible food residues.
3. Clean the storage bowl (8), the locking
nut (1), the screw conveyor (6) and the
mincing attachment (9) with warm water
and detergent.