BS CT STYLE Manual De Utilización página 20

(*) The "automatic stop timer" delays stopping of the hood,
which will continue functioning for 15 minutes at the operat-
ing speed set at the time this function is activated.
• Active carbon/grease filter saturation:
- When button A flashes at a frequency of 2 seconds, the
grease filters must be cleaned.
- When button A flashes at a frequency of 0.5 seconds, the
carbon filters must be replaced.
After the clean filter has been replaced, the electronic memory
must be reset by pressing button A for approximately 5 sec-
onds, until the light on the button stops flashing.
• Controls (Fig.11):
NOTE: With this command the appliance can also be con-
trolled with a remote control to be requested as an accessory.
Power key (A) = If the appliance is set up to support other
functions such as automatic openings, room lights, etc., this
key enables these functions.
Attention! In some models this key does not enable any
function and if pressed it turns on the corresponding LED for
approximately 15 sec.
-OFF key (B) = Key for reducing speed and switching off.
+ON key (C) = From the OFF position, by pressing the C
key once, the motor goes to 1st speed, twice for 2nd speed,
three times for 3rd speed; at each speed change, the LED
changes colour.
By pressing the B key, the speed reduces and the LED turns
to the typical colour of the speed.
Intensive key (D) = With the motor running and at any speed,
pressing the D key inserts the INTENSIVE speed (4th speed)
for 10 minutes. During this function the LED flashes, and the
speed LED previously set turns out.
After 10 minutes, the hood returns for the last set speed with
the relative LED indication.
- If you wish to deactivate the function before the 10 minutes
are up, press the B key.
- The INTENSIVE speed function will not activate when the
hood is off.
Light key (E) = Pressing this key adjusts light intensity.
- There are three light intensity levels: high, medium, low.
From the off position, press once for the high level, twice for
the medium level, three times for the low level, and four times
to turn the lights off.
Light intensity is cyclical: high, medium, low, off.
Timer key (F) = With any speed inserted (except for intensive
speed) pressing this key activates the Timer function. The
LED of the Timer key flashes and the speed LED remains on.
- 15 minutes after the count is over, the hood turns off (mo-
tor and lights).
• By pressing the B key for 2 seconds (with the hood up) the
"clean air" function is activated.
This function activates the motor for 10 minutes everyr hour
at 1st speed, during which the LED corresponding to the B
key remains on.
During the remaining 50 minutes, the LED of the C key flashes
with the motor off, while the B key LED remains on, indicating
that the function is still active.
In order to deactivate the "clean air" function, press any key
except for the LIGHTS.
• Anti-grease/active charcoal filter saturation:
- After 30 h of operation, the LED of the B key begins to flash
; this means that the anti-grease filters must be washed.
- After 120 h of operation the LED of the E key begins to
flash; this means that the charcoal filter must be washed
or replaced.
Once the clean filter has been put back in place, the electronic
memory must be reset by pressing the C key for approximately
4 sec. until it stops flashing and the 30 h/120 h setting restarts
from zero .
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 20 -