boso medistar S Manual Del Usuario página 19

measurements), the oldest measurement is
deleted and the latest one stored.
Invalid measurements are not stored in the
memory.
If symbol appears following a completed
measurement, it is recommended that the
measurement is repeated while holding the
arm motionless (see also page 21).
A renewed display of symbol
the repeat measurement with the arm being
held motionless, can be an indication of irregu-
lar heart beat. Discuss this matter with your
GP on your next visit.
The unit switches off automatically after
approximately one minute. To repeat a measure-
ment, press the START button again.
Aborting a measurement
A measurement can be aborted at any time by
pressing the START button. The cuff is then
automatically deflated. In case of error, you
can always remove the unit at any time by sim-
ply opening the cuff.
Recording of measurements and
Bringing-up of Average Value
Record the measured values into the record
card that accompanies your unit as follows:
Enter each individual reading.
Recall the average value after 30 measure-
ments and enter it in its designated column.
By swiftly pressing the MEMORY button while
the unit is not in use, stored measurements can
be recalled.
following The average value of all stored measurements
(for systole and diastole) is showed afterwards.
The mode „pulse" shows the number of stored
measurements.
If there is no measurement stored in the
memory, the display for the number of
measurements taken flashes „ AOO ". The
systole and dia-
stole
each show „ O0 ".
displays
Average value
Systole
mmHg
Average value
Diastole
mmHg
Number of
measurements
19