Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
H-5799, H-5800
SEMI-RECESSED
FIRE EXTINGUISHER
CABINET
TOOLS NEEDED
Drill
Phillips Head Screwdriver
Plexiglass Window x 1
MOUNTING DIAGRAM (TOP VIEW)
ATTACHMENT
SCREW
CABINET
FRAME
1¼"
1. Remove everything from inside cabinet.
2. Build a frame around the cabinet inside the wall to
ensure structural stability.
PAGE 1 OF 6
1-800-295-5510
uline.com
Handle x 1
MOUNTING
FRAMING
TUB
DRYWALL
DOOR STOP
HINGE
2½" or 3"
TRIM
DOOR
PARTS
Latch x 1
NOTE: On load-bearing walls, the studs must
be doubled on either side of the cabinet tub.
If a stud must be cut to install the cabinet, a
load-bearing header must be installed in the
cabinet tub.
3. Place cabinet in position and mark location of
attachments on studding using holes in cabinet as
marking guides. Cabinet must be attached by at
least four points, two of which must be in studs.
4. Remove cabinet and drill 5/32" holes through studs
at marked points. Install plastic wall anchors in no
more than 2 places if needed. For masonry walls,
install expansion shields in wall at marked points.
5. Place cabinet in position and attach with universal
#10 x 2½" self-drilling screws (not included).
6. Check cabinet door assembly for binding or
gapping and shim as necessary.
Para Español, vea páginas 3-4.
Pour le français, consulter les page 5-6.
Flat-End Bolt x 2
Screw x 6
Bracket x 4
0421 IH-5799
Publicidad
Resumen de contenidos para Uline H-5799
- Página 1 Para Español, vea páginas 3-4. Pour le français, consulter les page 5-6. H-5799, H-5800 1-800-295-5510 uline.com SEMI-RECESSED FIRE EXTINGUISHER CABINET TOOLS NEEDED Drill Phillips Head Screwdriver PARTS Plexiglass Window x 1 Flat-End Bolt x 2 Latch x 1 Screw x 6...
- Página 2 Phillips head screwdriver, four brackets and screws. Do not over tighten. (See Figure 1) Figure 3 Figure 1 2. Attach handle to door using Phillips head screwdriver and two flat-end bolts. (See Figure 2) Figure 2 1-800-295-5510 uline.com PAGE 2 OF 6 0421 IH-5799...
-
Página 3: Herramientas Necesarias
H-5799, H-5800 800-295-5510 uline.mx GABINETE PARA EXTINTORES SEMIEMPOTRADO HERRAMIENTAS NECESARIAS Taladro Desarmador de Cruz PARTES 1 Ventana de Plexiglás 2 Pernos con Extremo Plano 1 Pestillo 6 Tornillos 1 Asa 4 Soportes INSTALACIÓN DIAGRAMA DE INSTALACIÓN (VISTA DE LA PARTE SUPERIOR) 3. -
Página 4: Ensamble
No los apriete demasiado. (Vea Diagrama 1) Diagrama 1 2. Fije el asa a la puerta usando el desarmador de cruz y dos pernos con extremo plano. (Vea Diagrama 2) Diagrama 2 800-295-5510 uline.mx PAGE 4 OF 6 0421 IH-5799... -
Página 5: Outils Requis
H-5799, H-5800 1-800-295-5510 uline.ca ARMOIRE À EXTINCTEUR SEMI-ENCASTRÉE OUTILS REQUIS Perceuse Tournevis cruciforme PIÈCES Vitre en plexiglas x 1 Boulon à tête plate x 2 Loquet x 1 Vis x 6 Poignée x 1 Support x 4 INSTALLATION 3. Mettez l'armoire en position et marquez SCHÉMA D’ASSEMBLAGE (VUE DU DESSUS) - Página 6 Évitez de Figure 3 les serrer excessivement. (Voir Figure 1) Figure 1 2. Fixez la poignée à la porte à l'aide d'un tournevis cruciforme et de deux boulons à tête plate. (Voir Figure 2) Figure 2 1-800-295-5510 uline.ca PAGE 6 OF 6 0421 IH-5799...