Important Safety Instructions; Installation Warnings - Tripp-Lite DMTP55NO Manual Del Propietário

1. Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the operation of this product.
Failure to heed these warnings may cause product damage, accident, fire, electric shock, serious injury or
death. The warranty may also be affected.

1.1 Installation Warnings

• Install the product indoors, away from excess moisture or heat, conductive contaminants, dust or direct sunlight.
• Do not install the product near flammable or flame-producing objects, radiators, hot-air vents, stoves or other heat sources.
• Do not use extension cords to connect the product to an AC outlet.
• Connect the AC input power cord directly to a properly grounded 120V AC power outlet. Do not overload the outlet.
• Do not place or mount the product on any unstable or uneven surface, including any surface that isn't level.
• Do not block any ventilation openings.
• To reduce the risk of fire or electric shock, do not expose the product to rain or moisture.
• Do not place objects on or hang objects from the unit.
• Leave at least 4 inches (10 cm) of open space around the display for proper ventilation to reduce the risk of product
damage or fire.
• Place the product in the installation location before removing it from its shipping container. At least four people are required
to move the product safely without mechanical assistance. Observe proper lifting form to reduce the risk of injury. If a
mechanical assistance device is used to move the product, ensure that the outer carton is not pierced.
• When positioning the product, hold it by the handles behind the display and by the bottom edge (but not the bottom
corners). Keep the product horizontal and upright. Handle it gently and do not drop it.
• To prevent injury and product damage, securely mount the product in accordance with the accompanying mobile floor stand
installation instructions (if applicable). Use only with an approved replacement specified by the manufacturer.
• Use caution when moving the product with the mobile floor stand (if applicable) to avoid injury or hardware damage.
• To mount the product to the wall, use a Tripp Lite VESA-compatible display mount, such as model DWMSC3780MUL. The
wall must be solid, sturdy, stable, smooth and completely vertical. Confirm that the display mount, anchors and wall are
able to bear the full weight of the product before mounting.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Do not allow any object to impact or fall into the product.
• Do not press against or stress the front panel of the product.
• Avoid dust, chemicals, oils, high humidity and other harsh environmental contaminants and conditions.
• Do not place the product in an application where it will be required to operate continuously without first consulting the
manufacturer.
• Keep all packing materials and small objects out of the reach of children.
• Do not allow children to climb or play on the product, nor any furniture, stands or mounts connected to the product.
• For best performance, keep the indoor temperature between 32º F and 104º F (0º C and 40º C).
• Do not expose the product to direct air conditioning.
1.2 Connection Warnings
• Use only the AC input power cord supplied with the product, or an approved replacement specified by the manufacturer.
• Confirm that the AC input power cord is securely connected to the product's power inlet.
• Do not modify the plug, and do not use an adapter that would eliminate the ground connection.
• Do not bend the AC input power cord excessively, nor place heavy objects on the power cord. This may damage the cord.
• Do not unplug the AC input power cord from the display while the product is operating.
• Unplug the product during lightning storms or when it will be unused for long periods of time.
• When unplugging the AC input power cord, firmly grasp the plug, not the cord. Pulling on the cord may damage it.
• Do not attempt to use a damaged power cord, plug or outlet. This may cause an electric shock or fire.
2