Phcbi MCO-50AIC Instrucciones De Operación página 37

OPERATION/ALARM LOG
*When you press the up/down keys (△▽) while in the graph screen with the graph item on the upper left of
the screen highlighted [Fig. 5], the range of the vertical axis of the graphs changes as shown in the table.
Graph item
Temp
CO
2
Door
7. With the data item (Temp, CO
display highlighted [Fig. 5], press the right key (▷).
▶ The date is highlighted. [Fig. 7]
8. Use the up/down keys (△▽) to select the date of the data to be
displayed in a graph.
Each time the up/down key is pressed the date will go back or forth 1
day, and the data from the
selected date is displayed in a graph.
*If you press the enter key (ENTER) instead of the up/down keys (△▽),
the display changes to the Date Select screen [Fig. 8], so after using the
left/right keys (◁▷) to move the cursor to the digit you want to change,
change the numerical value using the up/down keys (△▽).
9. Press the enter key (ENTER).
▶ The log data on the selected date is displayed in a graph.
*If the entered setting value is out of the settable range, the following
message is displayed on the right side of the display. Press any key on the
control panel to display the Date Select screen [Fig. 8].
Date Select
<Right side of the display>
Note: The CO sensor is not stable during the preparation for the gas control. Therefore, the CO
2
log data may be different from the actual value.
Display range
60°C – 50°C – 40°C
Default values 50°C – 40°C – 30°C
40°C – 30°C – 20°C
30°C – 20°C – 10°C
20°C – 10°C – 0°C
25% – 20% – 15%
20% – 15% – 10%
15% – 10% – 5%
Default values 10% – 5% – 0%
, or Door) on the upper left of the
2
Invalid Value
Press Any Key
DD/ MM /YY
↑ ↓
↑ ↓
↑ ↓
↑ ↓
↑ ↓
↑ ↓
↑ ↓
OP, CL
Temp 01/Jan/19
50°C
－
‐
40°C
－
‐
30°C
－
0 12
<Right side of the display>
Date Select
01/01/19
DD/ MM /YY
<Right side of the display>
2
EXP.
24
[Fig. 7]
[Fig. 8]
density
37