PAPILLON Ranger 25 Manual De Instrucciones página 27

Ranger 25 - 92831
First check to which side the limb is bent. Then
make the initial cut from the bent side and finish
by sawing from the opposite side.
Pruning of standing Tree
Cut up from the bottom, finish down from the top.
7.Maintenance
Before cleaning, inspecting or repairing
the unit, make sure that engine has
stopped and is cool. Disconnect the spark
plug to prevent accidental starting.

MAINTENANCE AFTER EACH USE
1. Air filter
Dust on the cleaner surface can be removed by
tapping a corner of the cleaner against a hard
surface. To clean dirt in the meshes, split the
cleaner into halves and brush in gasoline. When
using compressed air, blow from the inside.
To assemble the cleaner halves, press the rim
until it clicks.
2. Oiling port
Dismount the guide bar and check the oiling port
for clogging.
3. Guide bar
When the guide bar is dismounted, remove
sawdust in the bar groove and the oiling port.
Grease the nose sprocket from the feeding port
on the tip of the bar.
4. Others
Check for fuel leakage and loose fastenings and
damage to major parts, especially handle joints
and guide bar mounting. If any defects are found,
make sure to have them repaired before
operating the saw again.

PERIODICAL SERVICE POINTS
1. Cylinder fins
Dust clogging between the cylinder fins will
cause overheating of the engine. Periodically
check and clean the cylinder fins after removing
the air cleaner and the cylinder cover. When
installing the cylinder cover, make sure that
switch wires and grommets are positions
correctly in place.
2. Fuel filter
(a) Using a wire hook, take out the filter from the
filler port.
(b) Disassemble the filter and with gasoline, or
replace with a new one if needed.
27