Automated Learning Process./Activating Code; Important - Craftmade ELLINGTON TRD60PLN4 Guia De Instalacion

10. Automated Learning Process./Activating Code.

Remote Control
2
III IV
II
1
I VI
3
4
6
ON ECE
5
1 2 3 4
12V
BACK
Remove battery cover on back side of remote control transmitter.
Install 12-volt battery (provided) in transmitter and wall control.
IMPORTANT: Store the transmitter away from excess heat or humidity. To prevent damage to transmitter,
remove the battery if not used for long periods.
Fan SPEED control buttons1:
Fan OFF button 2:
REVERSE function button 3:
LIGHTING button 4:
CODE SWITCHES and SET button 5: With fan power off, arrange CODE SWITCHES to desired code
DIMMING function 6:
ON/OFF slider switch 7:
Replace the battery cover on transmitter. Select decor cover for wall control and press firmly onto front of
wall control.

IMPORTANT:

Remote and wall
controls must be
V
SYNCHRONIZED with
fan in order to
properly function.
5
IMPORTANT:
The code switches in
remote and wall
controls MUST MATCH
SET
for fan to function
properly.
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and up-light (if applicable)
setting. Turn fan power on, press and hold SET button on back of
remote control and on wall control for 5 seconds within 60 seconds
of powering fan in order to synchronize with fan motor.
Dimming capability is determined by the type of bulbs provided
with the fan. If no bulbs are provided, dimming functions will
not work.
OFF position = D
[Wall control only] Use to turn wall control on or off
6
On position = ON
page 9
Wall Control
2
III IV
1
II V
I VI
3
7
OFF ON
5
12V
FRONT PANEL
4
5