Unpacking The Loudspeaker - Turbosound iX Serie Guia De Inicio Rapido

12
iX Series
Thank you for choosing a Turbosound loudspeaker product for your application. If you would like further information about this or any other Turbosound product,
please visit our website at turbosound.com.

Unpacking the Loudspeaker

After unpacking the unit please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future re-shipment.
Controls
(5)
(6)
(1) LCD SCREEN displays the current DSP module and parameter settings.
(2) ENCODER KNOB controls volume when the default DSP menu is active. Press the encoder knob to access DSP sub-menus and parameters. When the sub-menus
are active, rotate the knob to change parameters.
(3) OUTPUT XLR connector provides a mix output of INPUT A, INPUT B and Bluetooth input for connection to additional full range speakers and subwoofers.
(4) INPUT A/INPUT B combo jacks accept input signals using XLR, balanced ¼" TRS or unbalanced ¼" TS connectors.
(5) POWER switch turns the unit on and off.
(6) AC INPUT accepts the included IEC power cable for connection to a mains outlet.
(1)
(2)
(3)
(4)
iX DSP Menu Structure
Menu Sub-Menu
MAIN MENU (Page 1)
MAIN MENU (Page 2)
*iPhone and iPad are trademarks of Apple Inc. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license.
Android is a trademark of Google Inc. Windows is either a registered trademark or trademark of Microsoft Corporation in the United States and/or other countries.
iX Series Analogue Connection
Despite their sophistication, iX speakers offer straightforward analogue connectivity, and you can easily arrange the iX system to allow simple control of levels from
other devices, such as mixers. You can also daisy-chain multiple iX speakers using only the analogue connections, and then directly control the overall level from your
mixer's master fader.
For example, you have four iX speakers and a mixer with simple left-right stereo outputs. For typical operation, set the DSP volume and input gain settings on all
speakers to a flat "0 dB" setting. Connect the mixer's left and right stereo outputs to the first two speakers' analogue INPUT A connections (the left and right mixer
outputs will go to separate speakers). Then, run cables from the OUTPUT analogue connections to the remaining two speakers. In a similar way, subwoofers can also be
linked to the analogue OUTPUT.
Quick Start Guide
Fullrange Function
Displays level indicators and model name.
Rotate the encoder knob to adjust the output volume.
Press the encoder knob to enter the main menu.
Displays the following Bluetooth* status information:
Main Screen
• Bluetooth symbol indicates connection to audio and
remote control device (iPhone, etc.)
• "M" or "S" below the Bluetooth symbol indicate that
the speaker is linked to another iX speaker as MASTER
(left channel, "M") or SLAVE (right channel, "S").
Volume Rotate the encoder to change the output volume.
Sets input mixer gain for analogue input A and B, as well
INPUT
as Bluetooth.
Sets front logo illumination, LCD back panel contrast,
SETUP
device lock and master reset.
Lets you pair the speaker with mobile Bluetooth devices
BT
and link to another iX speaker as MASTER/SLAVE.
Selects from 4 preset equalisations, depending on
MODE
function and music type.
POSIT. Selects DSP compensation depending on the speaker
(Position) position: stand, wall or floor.
Allows adjustment of bass and treble control, high pass
EQ filter for use with a subwoofer, and applies phase inversion
to the output, if required.
INFO Displays model and firmware information.
EXIT Returns to main screen.
13