Operation; Additional Handle; Depth Stop; Fitting/Removing A Tool - Kompernaß Parkside PBH 800 A1 Traducción Del Manual De Instrucciones Original

Operation

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached .
♦ The gripping position of the additional
handle can be varied .
Turn the additional handle
pull the additional handle
a little way .
♦ Turn the additional handle
position .
♦ Now, slide the locking positions on the addi-
tional handle over the two locking pins on
the spindle of the appliance .
♦ Retighten the additional handle
by turning it in an anticlockwise direction .
NOTE
► Turn the additional handle
locking positions depending on your working
position . Undo and lock the additional
handle as described previously .

Depth stop

♦ Push the locking button for the depth stop
and keep it pushed in .
♦ Insert the depth stop
handle .
♦ Ensure that the toothing on the depth stop
facing downwards .
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop with the required drilling depth .
♦ Release the locking button for the depth stop
to lock the depth stop
■ 42 │ GB │ MT
clockwise and
off the appliance
to the desired
afterwards
into the various
into the additional
out until the distance
.

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Fitting a tool
♦ Before fitting a tool, grease the tool holder
lightly with machine grease .
♦ Place the tool in the tool holder
rotates until it locks automatically .
♦ Check that the tool is properly locked by pulling
it . The system has radial play because of the
design .
Removing a tool
♦ To release the tool, pull the locking collar
backwards .
Quick­release chuck for round shaft
drill bits
WARNING!
Do not use the quick-release chuck
►
for hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits
♦ Place the quick-release chuck
holder so that it rotates until it locks auto-
matically .
is
♦ Check that the tool is properly locked by
pulling it .
Removing the quick-release chuck for round
shaft drill bits
♦ To remove the quick-release chuck
locking collar
quick-release chuck
so that it
to the drill
in the tool
, pull the
backwards and remove the
.
PBH 800 A1