Maintenance And Cleaning - Vito Agro VIMP2810 Manual De Instrucciones

Work only in daylight or with good artificial lighting. Do
not use the equipment at night or when it is not possible
to have a clear view of the work area.
Never work with the pruning chain saw when adverse
metrological conditions such as dense fog, rain or strong
wind, storms or lightning.
When using the pruning chain saw, place yourself in a
stable position and always keep your balance.
Keep all parts of your body away from the cutting
accessory while using the appliance.
Always wear personal protective equipment and
clothing. Wearing a visor or goggles, dust mask, hearing
protection, anti-slip safety shoes, long-sleeved clothing,
gloves, helmet and shin guard properly reduces the risk
of injury.
Clothing worn during use of the equipment must be
adequate, tight and closed, for example, a work
boilersuit. Do not wear loose clothing or jewellery. Keep
hair, clothing and gloves away from moving parts.
Always wear security shoes with non-slip sole that fully
covers the foot.
In case of nausea, headaches, sight problems (eg.
reduced vision), hearing problems, dizziness and
reduced ability to
immediately. These symptoms may be caused by high
exhaust gas concentration.
The combustion engine releases poisonous gases as
soon as it starts running. These gases contain toxic
carbon monoxide, a colourless, odourless gas, as well as
other harmful substances. The combustion engine may
never be turned on inside confined or poorly ventilated
spaces.
While operating the pruning chain saw, plan breaks and
avoid using the pruning chain saw for long periods of
time. Permanent vibration is very harmful.
concentrate, stop working
Do not attempt to remove the wrapped material from
the cutting accessories and respective guards while the
engine is running or the cutting accessory is rotating.
Stop the engine and wait for all the accessories to stop
before removing the material wrapped around the
chain guide bar shaft.
A massive load of vibrations may damage nervous
and circulatory systems, especially to whom have
circulatory problems.
symptoms arise caused by vibration. Among these
symptoms, that occur specially on fingers, hand and
wrists, are also included loss of sensation, pain, muscle
weakness, skin discoloration or tingling sensation.
The control and safety devices installed in the chain saw
cannot be removed or inhibited.

Maintenance and cleaning

When carrying out any cleaning, adjusting, repairing or
maintaining work, wear gloves and place the pruning
chain saw in a firm and steady surface.
Keep the spark plug cap away from the spark plug,
as an unintentional spark can cause burns or an
electric shock. The contact of the spark plug with the
spark plug cap may cause an involuntary start of the
combustion engine.
Allow the chain saw to cool down in particular
before carrying out maintenance work on the
combustion engine, exhaust manifold and muffler.
Temperatures of 80 ° C and above can be reached.
Frequently check the equipment, especially before
storage (for example, before the winter period),
regarding wear and damages.
For safety reasons, replace worn or damaged parts
immediately so the appliance is always in perfect
operating conditions.
Cleaning:
The pruning chain saw must be carefully cleaned after
each use.
Inform your doctor if any
37