Bimar DH-FS02 Folleto De Instrucciones página 9

(dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces and
not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined
plane (the appliance could upset).
INSTRUCTIONS:
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer or a
competent qualified electrician or a person with similar qualifications, in order to
avoid any risk.

Open the metal support (1), put the appliance on a secure
surface (verify that the area around the surface is clean, without
dust).

Make sure that the fan is switched off (pos.0 ), (2).

The fan can be manually adjusted up and down by the air grating
in two position according to his inclination.

You can use the fan in the computer USB port or AC / DC
adapter (not included); check that the voltage values shown on
the data plate correspond to those of the AC/DC adaptor or PC,
in this case 5Vdc..
 Use with USB on your computer:
- Plug the USB into the computer (3), take care to properly orient the plug into the
USB port.
- Turn on the fan through the 0 / I switch on the back , in pos. "I".
- To turn off the device , select the 0 / I switch to pos. "0" and remove the plug
from USB into the computer.
 Use with AC/DC adapter (NOT included):
Insert the USB plug into the adapter , make sure to correctly orient the plug
-
into the USB port , insert the pina of the adapter into the power outlet.
Turn on the fan through the 0 / I switch on the back , in pos. "I".
-
To turn off the device , select the 0 / I switch to pos. "0" and remove the plug from the
socket .
When not in use for long periods, remove the USB connector from adapteur or from
the computer.
9