Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Existing Construction
B11
B12
EXISTING FAN
E
Remove an existing fan and check to make sure the open-
Move the housing into position above the ceiling.
ing is large enough to accommodate the new motor hous-
ing (7.25" x 7.75").
B13
B14
Route wires through the strain relief. For supply connection,
Attach existing ducting to duct connector. Tape joints.
use wires suitable for at least 90˚ C (194˚ F).
If ducting does not fit securely,
an adapter may need to be purchased.
B15
E
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
8
41938-01 3/29/2006
05-HF-024_EngS_3.29.06.indd 8
3/29/06 7:25:27 PM
Publicidad
Tabla de contenido
