Power Requirements; Door Locks - Tripp-Lite CSCSTORAGE1 Manual Del Propietário

Setup
Caution! Read All Instructions and Warnings Before Installation!
Warning: Storage carts can be extremely heavy. Do not attempt to unpack the cart without assistance. Follow the
unpacking instructions document that shipped with this product before proceeding with setup. Use extreme caution
when handling the cart, and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the cart.

Power Requirements

The cart must be plugged into an AC outlet with a dedicated circuit. An AC outlet with a 20-amp (NEMA 5-20R) AC circuit is
recommended for powering the cart. The AC outlet used to power the cart should not be shared. The total wattage of the cart
and all connected components should not exceed 1440 watts.
Installing the Handle Bracket and Corner Safety Bumpers
To install the handle bracket, choose a side on which to install the bracket (the same side as the cable access hole grommet
is recommended). Using the included hex key tool and four (4) hex screws, secure the handle bracket to the cart . Then
A
install the two top corner safety bumpers using eight (8) hex screws (four per bumper) .
B
A B

Door Locks

The doors contain a lock that is accessible with the included
keys.
4