Troubleshooting - Royal Sovereign RBC-2100 El Manual Del Propietario

tRouBLeShootIng

Note: when counting and detecting is not accurate, please check the machine as follows:
The power line cord is connected
well?
No power
The hopper sensor is dirty, please
clean with brush
The power is on,
but unit is not working
Turn the screw clockwise to
increase the friction
Wrong counting
Adjust the MG sensor
Wrong detecting
The fuse is worn out?
Connect the Hopper sensor line
well to the main board!
Counting sensor is dirty, please
clean it
Tight Loose
MG is dirty, please clean it
10
The power switch is on ?
The belt is too loose or too tight,
please adjust the belt.
Rubber tongue is worn out.
Change to other side or replace
with a new one.
UV sensor is broken or dirty,
please clean it or change a new
one