Error Code Displays - Royal Sovereign RBC-2100 El Manual Del Propietario

eRRoR CoDe DISPLAY
When an error code appears in the preset display window and the machine stops. Please refer to this chart for an explanation.
error code
The right counting sensor is broken or dirty
E01
The left counting sensor is broken or dirty
E02
The code disc is dirty or loosen
E03
The hopper sensor is broken or dirty
E04
The stacker sensor is broken or dirty
E05
Ambient light is too high
E10
UV sensitivity light is too high
The plastic button is broken
E11
The fake bill reflecting fluorescence is being
EE1
checked out by UV
The fake bill without magnet is being checked
EE2
out by MG
The half bill is being checked out
EE4
The left (right) counting sensor is dirty or
broken
The fake bill with different located magnet is
EE6
being checked out by MG
the bill width size is over 5mm larger than
EE8
the real USD bill size
Two bills are counted as one / inaccurate
EE9
counting
Malfunction causes Solutions
Clean or replace sensor
Clean or replace sensor
Clean or tighten sensor
Clean or replace sensor
Clean or replace sensor
Lower the ambient light
Lower the UV light
Replace button
Take out the first bill (fake bill) in the stacker then press [reset]
to continue counting and detecting
Take out the first bill (fake bill) in the stacker then press [reset]
to continue counting and detecting
Take out the half bill in the stacker, then press [reset] to
continue counting &detecting
Replace counting sensor
Take out the first bill (fake bill) in the stacker then press [reset]
to continue counting and detecting
Take out the first bill (fake bill) in the stacker and press [reset]
to continue counting and detecting
Fasten the adjustable screw clockwise
9
RBC-2100