Placement And Fine Tuning; Standard Surround Setup; Non-Skid Pads; Connecting Your System - Pioneer S-RS3TB Instrucciones De Operación

PLACEMENT AND FINE TUNING

FRONT SPEAKERS
For best results the loudspeakers should be separated a
distance approximately equal to the listening distance.
Angling the loudspeakers inward towards the listener will
improve the image stability for non-central listeners.
Close proximity to a side or rear wall will enhance the
midbass performance, although too close (particularly a
corner location) and the bass may be unnaturally high
and image performance may be degraded.
CENTER SPEAKER
The loudspeaker should be positioned below the TV. For
best results align the front of the loudspeaker with the
front of the TV. If the loudspeaker is placed under the TV
and very close to the floor, then tilting upwards may be
beneficial.
When installing the center speaker on top of the TV, be
sure to secure it with tape or some other suitable means.
Otherwise, the speaker may fall from the TV due to
external shocks such as earthquakes, endangering those
nearby or damaging the speaker.
SURROUND SPEAKERS
For best results the loudspeakers should be positioned at
or above ear level. Depending upon your room layout and
preferences, the left and right rear speakers should be
positioned on the side walls just the rear of the listening
position, or on the walls.

NON-SKID PADS

If the front, center and surround speakers are placed on
a hard surface, such as wood or tile place four non-skid
pads on the bottom flat surface of the speakers.
Front speakers
2
En
Center speaker
Surround speakers

STANDARD SURROUND SETUP

This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
Front
left
Listening position
Surround left

CONNECTING YOUR SYSTEM

Make sure all equipment is turned off before making any
connections.
• Correct wiring of your loudspeakers is essential for
achieving the best sound quality. Be careful to
ensure proper polarity of connection.
CAUTION
These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
Connect to the speaker terminals on the rear of
the amplifier.
To connect, insert the striped speaker wire into the red
(+) terminal and the other wire into the black (–) terminal
as shown below.
Striped half of speaker cable
Other half of speaker cable
Front
right
Center
Subwoofer
Surround right
D3-4-2-2-3_A_En