Mounting On The No. 120 Stand; Machine Inspection - RIDGID 1210 Manual Del Usuario

1210 Oil-less Threading Machine

Mounting On The No. 120 Stand

1. To set-up the Model 120 Stand, pivot the two (2)
outside legs about the center section of the stand until
the plunger pins lock into place. (Figure 2)
2. The stationary center leg holds a larger guide. This
center leg and guide must be positioned at the REAR
of the machine.
3. To mount the Model 1210 Threading Machine on
the No. 120 Stand, grasp the Model 1210 machine by
both the front and rear carrying handles.
4. Position the Model 1210 so the REAR of the machine
is above the guide of the stationary center leg of the
stand. The front corners of the machine should be
above the two (2) smaller guides.
5. Lower the machine onto the mounting pins of the
stand. The guides will help to properly position the
machine. Insert retaining pin through hole in front
guide of stand to capture machine. (Figure 3)
Before letting go of the Model 1210, be
WARNING
sure the stand mounting pins are properly engaged
into the threading machine. Retaining pin must be prop-
erly inserted before using the machine.
Figure 2 – Model 120 Stand in OPEN Position.
Figure 3 – 1210 Machine Mounted on Model 120 Stand

Machine Inspection

To prevent serious injury, inspect your Threading
Machine. The following inspection procedures
should be performed on a daily basis:
1. Make sure Threading Machine is unplugged and the
switch is set to the OFF position (Figure 1).
2. Clean the speed chuck jaws with a wire brush.
3. Inspect the jaw inserts for excessive wear. Refer to
the Maintenance Instructions if they need to be re-
placed.
4. Make sure the foot switch is present and attached to
the Threading Machine (Figure 1).
WARNING
chine without a foot switch.
5. Inspect the power cord and plug for damage. If the
plug has been modified, is missing the grounding
pin or if the cord is damaged, do not use the
Threading Machine until the cord has been replaced.
6. Inspect the Threading Machine for any broken, miss-
Ridge Tool Company
WARNING
Do not operate the Threading Ma-
5