Eldom WRK2500 Manual Del Usuario página 20

NOTE
Do not exceed the maximum time of continuous operation of the device. Any failure
to comply with the above, as well as any failure to keep the device idle for the required
time may irreparably damage the engine and render the warranty void.
If the device blocks during operation, before cleaning, disconnect it from the mains
and wait until the attachment stops moving.
If the device slows down during mixing or whisking, stop the operation and thin the
mixed or whisked product. To prevent the ingredients from flowing out of the bowl
during mixing, do not fill the bowl above 2/3 of its volume.
Place the device on a flat, hard and stable surface.
BLENDER
Installation
- place the appliance on a flat, hard, and stable surface,
- make sure that the appliance is disconnected from the mains, and the power switch (2)
is set to the "0" position,
- lock the base arm (4) in the horizontal position,
- remove the cover from the seat (5) and install the blender container (14) in it - fig. IV,
CAUTION
The appliance will not switch on if the blender container (14) and the blender lid (13)
are not properly fitted.
The appliance will not switch on if the base arm (4) is not lowered and locked.
OPERATION
- place food products in the container (14) - DO NOT EXCEED the maximum level,
CAUTION
Do not switch on the appliance if there is no liquid (e.g., water, juice, etc.) in the
container (12).
- put the blender lid (13) on the container (14) and lock it by turning it to the right,
- insert the stopper (12) into the lid (13),
- the appliance starts when the speed has been selected with the switch (2); by changing
its position the user can set 8 different speeds,
- pulse operation is activated through rotating and holding the switch (2) in the "P"
position. Releasing the switch results in an automatic return to the "0" position.
- the products can be added both before installing the container (14) in the seat as well as
during appliance operation using a special opening in the lid (13),
CAUTION
Observe the continuous operation time of the appliance. Excessive operation time and
lack of sufficient breaks can lead to irreversible motor damage and loss of warranty.
In case the appliance is blocked during operation, before cleaning, disconnect it from
the mains and wait until the installed blade has stopped.
20