NORTH STATES 5264 Instrucciones página 3

Step 2
To add an extension, begin by removing both the upper and lower plugs from the side of
the gate frame. You may need to use a athead screwdriver to remove the plugs. Figure 2A.
• Attach both the upper and lower extension connectors to the extension pole.
• Install the fully assembled extension by inserting the upper and lower extension
connectors into the gate holes where you removed the plugs. Figure 2B.
• Replace both plugs. Place the tension knobs onto the spindles and insert the spindles
into the holes located on the outside of the extension. Figure 2C.
2A
Step 3
Attach gate stopper to the lower bar on the door frame.
NOTE: Insert gate stopper so the arrow is facing up and the stopper knobs slide down.
Step 4
Insert the front latch (K) and the back latch (L) into the
bottom of the pet door frame. Ensure the release button
on the latch is facing up. Firmly connect them together
to lock into place.
NOTE: Do not connect latch together prior to inserting
the latch into the pet door, as it will not come apart once
it is connected.
Step 5
Align and secure with wall cups onto your wall with tape pads or screws.
NOTE: Make sure the bottom of the gate frame remains completely at on the oor.
Step 6
Tighten both top and bottom tension knobs inward towards the gate.
To ensure safe installation with proper gate installation, continue to tighten tension
knobs until the gap between the upper latch and the upper gate frame housing is
eliminated.
2B
Upper plug
Lower plug
I
A
D
C
2C
K
C E
C
E
Page 3
L