Operation And Use; Normal Operation - SOMFY Dexxo Pro 800 RTS Manual De Utilización

OPERATION AND USE

Normal operation

Operation in «Total opening» mode with a Keygo type remote control or similar (Fig. 5a)
Operation in «Partial opening» mode with a Keygo type remote control or similar (Fig. 5b)
Obstacle detection operation (Fig. 6 and 7)
When an obstacle is detected during the open cycle, the door will stop (Fig. 6).
When an obstacle is detected during the close cycle, the door will stop and then reopen (Fig. 7).
Light operation
The light will come on each time the motor drive unit is operated. The light will go out one minute after the door stops moving.
Manual release cord operation (Fig. 8)
release mechanism should be easily accessible and located no more than
[1]. Disengaging the motor drive mechanism
Pull on the manual release cord until the door drive mechanism is disengaged.
[2]. Manually moving the door
This is possible as long as the door drive mechanism is disengaged.
[3]. Reengaging the motor drive mechanism
Move the door manually until the drive mechanism comes to reengage itself into the transmission rail.
When disengaging the motor drive mechanism, use caution for a badly balanced door may cause sudden door movement that
may be dangerous.
Only use the cord to disengage the motor drive mechanism. Never use the cord to move the door manually.
Always reengage the motor drive mechanism before sending another command to the motor drive unit.
6
5a
5b
8
7
3