How To Modify Programs Program Mode - Kinetec Breva Manual Del Usuario

Use of the hand control

How to modify programs PROGRAM MODE ?

Beginning
To switch off the unit
Press the two keys at the same time and switch the
unit ON
Then
To change the program if necessary
To choose the movement
To display the extension or flexion limit of the
movement
To change the limit of movement if necessary
To validate the new value, press another key
or wait more than 3 seconds
To record the program 10
Then
OR
To cancel the program
To exit program mode, switch OFF and switch ON
the unit.
Comments:
• The values shown in the 'Display' column are examples.
GB
8
Keys to press
Program
Program
Or
RIGHT PROG NR10
10 INV/eve 10
left PROG NR10
10 INV/eve 10
Program
20
Program
20
Or
Program
20
Program
Or
20
Program
Program
Load : _____
Program
Timer disable
Program
Pause pl
Program
Save :+
Program
Program
Program
Program
Display
KINETEC
BREVA V01.0
1
EMPTY
10
EMPTY
10
pl/dor 0
10
pl/dor 0
10
pl/dor 0
10
pl/dor 20
10
Speed : 1
10
10
10
0s
10
clear :-
10
Saving
11
EMPTY
10
CLEARING
11
EMPTY
KINETEC
BREVA V01.0
Remarks
Welcome text during 3 seconds
The program number blinks.
The new program number blinks.
The display shows the new movement
selected.
After the selection of the movement press
the Warm Up key to validate it.
The value blinks.
The new value blinks.
While the value blinks press the (+) or (-)
key to change if necessary.
The program 10 has been recorded and the
display indicates the next program so you
can change another program.
The program 10 has been cancelled and
the display indicates the next program so
you can change another program.
To use the modified program see page 10.