Kinetec Breva Manual Del Usuario página 34

Use of the hand control
How to define the patient tolerance • At the start of a session
This function, MODULATION Mode is a way to set within the tolerance of a patient at the beginning of a session.
Set up the patient and proceed as below:
Beginning
Switch the unit ON
To choose the movement
To select the MODULATION Mode
To select the pain level
( key + for flexion, Key - for extension)
To set the pain level when reached, immediately
press
To start the session with the new movement limits
Comment: arrived at the limit max of the movement the angle max is automatically recorded and exit of the function.
How to define the patient tolerance • During the session
This function, The BY-PASS MODE is a way to address the pain threshold of a patient during a session.
IMPORTANT: Can be used only when the machine RUN
Beginning
The unit is running
To select the BYPASS mode
To select the new discomfort level
To select the new discomfort level when reached,
immediately press
Continue the session with the new movement limits
Comment: arrived at the limit max of the movement the angle max is automatically recorded and exit of the function.
GB
12
Keys to press
BREVA V01.0
PL/FLEX
Please wait
PL/FLEX
20
EV
10
PL/FLEX
20
MODUL. : use +or-
20
MODUL. : use +or-
Or
20 manual
Continuous press
MODUL. : use +or-
Or
20 manual
PL/FLEX
20
.
Keys to press
PL/FLEX
20
BYPASS :
20
BYPASS :
Or
20BYPASS
Continuous press
Or
BYPASS :
30BYPASS
PL/FLEX
30
Display
KINETEC
DOR/FLEX
DOR/FLEX
STOP 18 20
RIGHT INV
STOP 18 18
The display shows the new movement
selected.
DOR/FLEX
STOP 18 20
The display indicates the keys to be used to
drive the machine, this message is
STOP 18 20
displayed 3 seconds.
The unit is moving to the selected way.
28 28 It is waiting for you to select new limits.
The new limit of the movement is recorded.
28 28
DOR/FLEX
The angle display changes with current
RUN 15 28 movement.
Display
DOR/FLEX
Check if the hand control is not blocked
RUN 15 28 (See page 7).
The display indicates the keys used to run
USE +or-
the machine.
RUN 20 28
This message is displayed 3 seconds.
USE +or-
The unit is moving to the selected way.
30 28 It is waiting for you to select new limits.
USE +or-
The new limit of the movement is recorded.
30 28
DOR/FLEX
The angle display changes with current
RUN 17 28 movement.
Remarks
Remarks