SEVERIN SM 9685 Instrucciones De Uso página 9

danger if frothing milk is forced out.
Caution: Th e lid with insert must be
fi tted during operation.
Caution: Th e milk container heats up
during operation. Do not touch hot
surfaces.
Hold the container only by its handle.
Th e appliance may only be used with the
original accessory parts provided by the
manufacturer.
Th e appliance must always be set on a fi rm,
level surface.
Do not allow the appliance or its power
cord to come into contact with open
fl ames or any hot surfaces such as hot-
plates.
Do not allow the power cord to hang free;
the cord must be kept well away from hot
parts of the appliance.
Always remove the plug from the wall
socket
- in case of any malfunction,
- aft er use,
- to turn the appliance off completely,
- before cleaning the appliance.
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Th is appliance is intended for domestic or
similar applications, such as in
- staff kitchens,
commercial environments,
- agricultural areas,
- hotels, motels
establishments,
- bed-and-breakfast guest houses.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service
address can be found in the appendix to
this manual.
All manuals and user guides at all-guides.com
offi ces and other
etc. and similar
departments. Th e
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or aft er extended periods of non-use, it
should be thoroughly cleaned as described in
the section General Care and Cleaning.
Operation
We recommend the use of long-life low-fat
milk (UTF, 1.5% fat content). For best results,
the milk should be taken from the refrigerator
immediately before frothing.
Th e underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
– Use the smooth stirring head to heat up
milk.
– For frothing and heating milk at the same
time, use the serrated head.
– For cold-frothing milk, also use the
serrated head.
– When not in use, the stirring heads may be
safely stored at the rear of the housing.
Fill amounts
– Always observe the minimum mark and
ensure the container is fi lled with at least
100 ml milk.
– For frothing, fi ll the container to a
maximum of 350 ml (lower max mark
).
– For heating, fi ll the container to a
maximum of 700 ml (upper max mark
).
Heating up or frothing milk
1. Place the container onto the base.
2. Remove the lid from the milk
container.
3. Place the appropriate head onto the
mounting protrusion inside the bottom
of the container.
4. Put the required amount of milk into
the container.
9