Belkin TuneCommand Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions
STEP 2 - TuneCommand Remote Setup
1. Turn your Remote with the buttons facing
down. Press the release button to open
the battery tray, and gently pull it out of
the housing until it stops (Fig. 2). Please
do not force the battery tray completely
out of the housing.
2. Insert the battery with the (+) side facing
up (Fig. 3) and push the battery cover
back into the Remote until the button
snaps back into place.
3. Now press any of the Remote's buttons
for the TuneCommand Remote and
Receiver to pair up. The green lights on
the Receiver and the Remote blink when
the first button press command from the
Remote reaches the Receiver correctly.
Operating Instructions
|
4
P74852ea_F8Z024ea.indb Sec1:4-Sec1:5
P74852ea_F8Z024ea.indb Sec1:4-Sec1:5
Operating Instructions
STEP 2 - TuneCommand Remote Setup
Use the stereo connector on top of the TuneCommand Receiver to
Fig. 2
connect your iPod to your stereo system. As an alternative, you can
connect to your stereo system via the iPod device's docking cradle
and its built-in line-out port.
You can now use your TuneCommand Remote handset to control the
Fig. 3
iPod device's play/pause, skip forward, skip backward, and volume
up/down functions. In addition, you can conveniently control the
shuffle and repeat functions, using the two small round buttons.
Each press of a button advances the setting to the next stage. When
used with the iPod photo, TuneCommand lets you scroll through your
slideshows or presentations—wirelessly.
The shuffle key
follows:
Shuffle off > Shuffle songs > Shuffle albums.
The repeat button
this:
Repeat off > Repeat one > Repeat all.
Follow the icons on the iPod device's screen to see the current
settings, represented by small icons on the upper right, below the
battery status indicator.
advances the iPod device's shuffle settings as
advances the iPod device's repeat settings like
EN
NOTE: To avoid damage to
the Mounting Port, do not
move the Receiver back
and forth.
Operating Instructions
|
5
10/8/05 9:29:59 am
10/8/05 9:29:59 am

Publicidad

Tabla de contenido
loading

Tabla de contenido