Troubleshooting Tips - sunjoe iON8PS2-LT Manual Del Operador

Federal Communications Commission (FCC)
m
WARNING!
Any changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Class B device:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Troubleshooting

Troubleshooting Tips

Most difficulties are easy to fix. Consult the troubleshooting table for common problems and their solutions. If you continue to
experience problems or need repairs beyond these minor adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
m
WARNING!
Always remove the battery before performing any adjustments, maintenance or repairs to your cordless
pole chain saw.
Fault
The motor does not start
when you switch it on
The motor stops
during operation
Reduced battery
power reserve
The battery charger does
not charge the battery
(green indicator light on)
The battery charger does
not charge the battery
(no red LED on)
Possible Cause
• No battery or not
inserted correctly
• Battery exhausted
• No battery or not
inserted correctly
• Battery exhausted
• Difficult operating
conditions absorbing
more current
• Dirty contacts
• No power supply to
battery charger
• Defective battery charger
21
Remedy
• Make sure that the battery is properly inserted
• Check charge status and recharge the battery
• Make sure that the battery is properly inserted
• Check charge status and recharge the battery
• Optimize use
• Clean contacts
• Check that the plug is properly inserted and that
the socket receives power
• Replace with OEM charger (model# iCHRG40)