Remote Control - Blumfeldt Heat Square Manual Del Usuario

OPERATION
Note: The heater must be properly installed before use.
This appliance is equipped with an on/off switch:
• Connect the heater to a grounded outlet.
• Do not operate the heater unless it is in an upright position.
• The heater is equipped with three heating levels.

Remote control

A. Press the On/Off switch to activate the heater.
B. To operate the heater at 1000W, press the left or right side button on the
remote control.
C. To operate the heater at 2000W, press both the left and right side buttons
on the remote control.
D. To turn on the LED light, press the upper button on the remote control.
Activation button
A. Press the On/Off switch to activate the heater.
B. Press the button once to operate the heater at 1000W.
C. Press the button twice to operate the heater at high 2000W power.
D. Press the button three times to activate the LED ambient lighting without
heat.
E. Press the button four times to activate the LED backlight and operate the
heater at 2000 W power.
F. Press the button five times to turn off the light and heater.