Installation And Connections; Connection Panel - My Audio ILLUNIS ACTIVE Serie Manual De Instrucciones

■
ILLUNIS 8A: it is fitted with a 1" compression driver horn and with a 8" woofer. The built-in power module includes one
180W RMS H amplifier for the low section and one 30W RMS AB class amplifier for the high section.
■
ILLUNIS 6A: it is fitted with a 1" compression driver horn and with a 6" woofer. The built-in power module includes one
100W RMS H amplifier for the low section and one 30W RMS AB class amplifier for the high section.
The models with bi-amp power amplifiers are fitted with high-precision active crossover and independent limiters for the
high and the low section.

5. INSTALLATION AND CONNECTIONS

1. INSTALLATION
All the ILLUNIS Active series models are fitted and created for the installation on a standard loudspeaker stand.
Thanks to the shape of their cabinet, the models of ILLUNIS Active series can be placed on the floor in horizontal position
and used as stage monitor.
2. CONNECTIONS
The inputs of the ILLUNIS Active loudspeaker systems can be used with line signals coming from devices with high-level
outputs. For the connection, use BALANCED signal cables with XLR or JACK connector.
The input level of the incoming signal can be set using the VOL control. If you are using devices with a too high output
level, you can reduce the input gain turning the control counter clockwise. If you need to send the same signal to a
second loudspeaker system, you can use the XLR-M LINK connector.
3. SUB + SATELLITE SYSTEMS
Thanks to their versatility, all the ILLUNIS powered can be used together with the LUNARIS Active Sub-woofers.
In the following configurations you can find the suggested subwoofer + satellite setups for the ILLUNIS Active speakers.
■
1 x LUN18 SA + 2 x NIS12 A
■ 2 x
LUN18 SA + 2 x NIS12 A
■
1 x LUN15 SA + 2 x NIS10 A
■ 2 x
LUN15 SA + 2 x NIS10 A
■
1 x LUN12 SA + 2 x NIS8 A
■ 2 x
LUN12 SA + 2 x NIS8 A
■
1 x LUN12 SA + 2 x NIS6 A
■ 2 x
LUN12 SA + 4 x NIS6 A
■ 2 x
LUN15 SA + 6 x NIS6 A
6. CONNECTIONS PANEL.................................................Fig. 3
1. INPUT COMBO CONNECTOR
According to the LINE/MIC selector position, you can connect line or microphone signals. For the connection use BALANCED
signal cables with XLR or JACK connectors.
2. XLR-M LINK CONNECTOR
It sends the signal towards another speaker or another equipment.
www.myaudio.it
- ILLUNIS ACTIVE SERIES -
ILLUNIS ACTIVE