My Audio ILLUNIS ACTIVE Serie Manual De Instrucciones página 9

3. LINE/MIC SELECTOR
Use this button to select the input sensitivity of the built-in amplifier. In the LINE position (button up) the input accepts
line signals from equipment with high-level outputs.
In the MIC position (button down) the input accepts the signal coming from a dynamic microphone without using any external
mixer.
4. VOLUME
Level control of the signal sent to the built-in amplifiers. The nominal sensitivity is different according to the LINE/MIC
selector's position (LINE +4dB / MIC -40dB).
5. PRESET SELECTOR
The 4 PRESETS available in all models have been prepared in order to provide the loudspeaker systems with different
acoustical responses suitable for different applications, different kind of signal and different tastes. Here below you can
find a short description that can help you in the choice.
▻ FLAT: this PRESET has been prepared to provide the best frequency response for the reproduction of recorded music
and is suitable for DJs, installations in public venues and multimedia applications.
▻ STAGE: this PRESET provides a flat response, suitable for LIVE setups and for any applications requiring the 'natural'
response of the loudspeaker system.
▻ MONITOR: this is the PRESET to be chosen when the NIS Active are used as stage monitors. The frequency response
has been adjusted in order to compensate the reflections from the floor, while the mid-high EQ provides a clear and
intelligible sound.
▻ VOICE: this PRESET can be used when you connect a dynamic microphone directly to the speaker's input. The equalization
contained in this PRESET allows to get from the microphone a brilliant and intelligible response even without using a mixer.
6. LIMIT LED
It indicates when the CLIP LIMITER starts operating following the detection of a too high signal level being fed to the
amplifiers. In this case, the LIMITER lowers the signal level to avoid damage to the enclosure components and amplifier
clipping.
7. SHIELD
Control for separating the electrical earth from that of the chassis: under certain conditions, the SHIELD selector can
enable to break earth loops and to eliminate hum or other annoying noises.
8. ON/OFF LED
This LED glows when the unit is switched ON.
Note: it is normal for this LED keep glowing for a few seconds when the units is switched off.
9. ON/OFF SWITCH
10. POWER SUPPLY SOCKET or MAINS CABLE
www.myaudio.it
- ILLUNIS ACTIVE SERIES -
ILLUNIS ACTIVE