Shark ATV-DRAK Manual Del Usuario página 6

TEXTILE PARTS
A
C
REPLACING THE INTERIOR.
- Start the operation by sliding the plastic tabs
of the front of the head section in its housing
beginning with one side (Fig. A).
- Insert one end of the neck pad at the edge of
the helmet, and feed the remainder of the neck
pad beneath the edge of the helmet. Insert the
other edge of the neck pad at the other edge of
the helmet (Fig. B).
- Then, hook the Velcro bands (Fig. C-D).
10
B
D
WARNING! The polystyrene lining and
interior padding are critical to properly
fit your helmet on your head. An improper fit
could cause your helmet to become dislodged
in an accident, leaving your head unprotected
and resulting in severe head injury or death. If
you are not sure that you properly replaced the
comfort padding, DO NOT USE YOUR HELMET.
Contact your retailer for assistance or advise.
EASY FIT
Your helmet ATV-DRAK has been designed to pro-
vide additional comfort for eyeglasses wearers
A
SYSTEM OF AERATION
Upper ventilation:
The upper air intake allows air to enter onto
the upper part of the head and thus renew
the air in the head section. The channels
incorporated in the internal shock absor-
bers facilitate the circulation of air over the
surface of the head.
The quality and design of the textile comfort
parts contribute to the proper distribution
of air. The position of the upper ventilation
EASY FIT - VENTILATIONS
with the EASY FIT SYSTEM.
The 2 cheeks are made in order to provide an
easiest passage to the glasses arms.
B
system is designed to optimise the effec-
tiveness of its intake of air. Depending on
the type of your motorbike, the fairing may
reduce the effectiveness of this ventilation.
The ventilation is in the open position when
pushed backwards (fig. A) and closed when
pushed forwards (fig. B).
WARNING! Do not open or close any
vents while operating your motorcycle.
You could lose control of your motorcycle,
resulting in an accident, personal injury or
death.
11