Nacon REVOLUTION Unlimited Pro Controller Manual De Instrucciones página 7

NOTES:
- If the controller is not connecting, to the USB Bluetooth
to synchronise the controller to the receiver. The process is:
• ensure that the controller is OFF or turn it OFF,
• press and hold 'Share' + 'PS' buttons, on your controller, until the LED player
status indicator starts to flash,
• press the SYNC button on the USB Bluetooth
- If you are connecting a 2nd controller, to a free USB socket, then connect 1x
controller and 1x USB Bluetooth
- To switch off your controller, press and hold the 'PS' button, for 6 seconds, until
the controller powers OFF.
- When switching from Wireless mode to Wired mode you will see the on-screen
message: 'Controller was disconnected'. Press the 'PS' button to re-connect.
- If, during gameplay, you experience any latency or deactivation then please
adjust your USB receivers in the way shown below:
- The 'Mode Selection' switch on the back determines if the controller is working
in PS4™ Normal Mode (Position 1) or PS4™ Advanced Mode (Position 2).
- The PC Advanced Mode (Position 3) allows you to switch your controller into
the X-Input Mode for PC* use.
c. How to charge your controller
Your controller will charge the internal battery, in the following ways:
1/ When connected to the PS4™ system as a wired controller
2/ When being used as a wireless controller and the cable is connected to the
PS4™ system. In this option the internal battery will 'trickle' charge as the
battery is still being used to power the controller ;
3/ When connected to the PS4™ system, with the cable, as a wired or wireless
controller but the controller is in 'Sleep' mode or 'Powered' off.
To check the battery level, in any mode simply press and hold the 'Mic mute' button
on the underside of the controller (for more than 1 second). The profile LEDs will
then light up, as described above. You can now release the mic mute button.
*PC Advanced Mode not tested nor endorsed by Sony Interactive Entertainment Europe.
receiver (the sync LED will flash).
®
receiver first followed by the 2nd.
®
receiver, you may have
®
EN /