NSK Ti-max nano65LS Manual De Operación página 7

4-2 CA Bur
4-2-1 To Insert the Bur
1) Turn the Bur Lock Ring in the direction of the "
2) Insert the attached Bur Stopper fully into the chuck. (Fig.3)
3) Insert the Bur fully into the chuck until it stops.
4) Turn the Bur Lock Ring in the direction of the " " mark until it clicks.
4-2-2 To Remove the Bur
Turn the Bur Lock Ring in the direction of the "
4-2-3 To Remove the Bur Stopper
Remove the bur then insert the attached Bur Stopper Puller into the chuck. Pull out the Bur Stopper by
hooking it at the slit of the Bur Stopper. (Fig. 4)
6
" mark until it clicks.
" mark until it clicks then remove the bur.
Bur Stopper
Fig. 3
Bur Stopper Puller
Fig. 4