Troubleshooting - Hoover WINDTUNNEL T Serie Manual Del Propietário

5. troubleshootinG

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug vacuum before servicing.
probleM possible Cause
Vacuum won't
1. Power cord not firmly plugged
run into outlet.
2. Blown fuse or tripped breaker.
4. Thermal Protector activated.
System Check 1. Rinsable Filter and/ or HEPA
Indicator has
Filter is dirty.
turned red
2. Dirt Cup full and/ or clogged.
or
Vacuum won't
3. Broken or worn Belt.
pick up
4. Brushroll and/ or Hose
or
clogged.
low suction
5. Carpet height setting is
incorrect.
dust escaping 1. Dirt Cup full.
from vacuum
2. Dirt Cup not installed correctly. 2. Review Dirt Cup removal & replacement -
3. Hose not installed correctly.
4. Rinsable and/or HEPA Filter
not installed completely.
Powered Hand 1. Too much pressure being
Tool brushroll
applied to tool.
won't turn
2. Blockage.
3. Low vacuum suction.
Smoky/burning 1. Belt broken or stretched.
smell detected
2. Brushroll is clogged.
All manuals and user guides at all-guides.com
WARNING
! !
possible solution
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
4. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Clean Rinsable Filter and/ or HEPA Filter -
Pg.9
2. Empty Dirt Cup - Pg.8.
3. Replace Belt - Pg.12.
4. Check Hose - Pg.11. Check Brushroll - Pg.10.
5. Set Carpet Height Adjustment to appropriate
setting for carpet being cleaned - Pg.7.
1. Empty Dirt Cup - Pg. 8.
Pg. 8.
3. Review Hose installation - Pg. 7.
4. Review Filter Removal and Cleaning.
1. Continue using tool applying light pressure.
2. Remove blockage - Pg. 11
3. Check items under "Vacuum won't pick or
Low suction."
1. Replace brushroll belt - Pg. 12.
2. Clear/ remove debris from brushroll - Pg. 10.
13