EMKO ESM-3723 Serie Manual De Instrucciones página 12

Humidity Alarm Set Parameter
This parameter value can be programmed between humidity minimum alarm set
parameter and humidity alarm set maximum
Humidity Alarm Hysteresis
This parameter value can be adjusted form 0 to %50 of the device scale.
Humidity Alarm Set Minimum Parameter(Default =Minimum Value of Device Scale)
if humidity alarm is active, this parameter value can be adjusted from minimum value of
device scale to humidty alarm set maximum parameter value.
Humidity Alarm Set Maximum Parameter(Default =Maximum Value of Device Scale)
if humidity alarm is active, this parameter value can be adjusted from humidity alarm set
minimum parameter
Humidity Alarm On Delay Time Parameter
Humidity Alarm On Delay Time can be defined with this parameter. It can be adjusted
from 0 to 99 minutes.
Humidity Alarm Delay After Power On Parameter
When power is first applied to the device, this time delay must be expired for activation of
Humidity alarm. It can be adjusted from 0 to 99 minutes.
Buzzer Function Selection
Buzzer is inactive.
Buzzer is active during temperature alarm
Buzzer is active during humidity alarm
Buzzer is active during Temperature sensor failures.
Buzzer is active during Humidity sensor failures.
Buzzer is active during Temperature sensor failures or temperature alarm.
Buzzer is active during Humidity sensor failures or Humidity alarm.
Buzzer is active during Temperature sensor failures or Humidity sensor failures
Buzzer is active during Temperature sensor failures or Humidity sensor failures
or temperature alarm or humidity alarm.
Buzzer Active Time ( Default =
If buzzer function selection parameter
Buzzer active time can be define with this parameter. It can be adjusted from 1 to 99
minutes. When this parameter is 1, if decrement button is pressed,
this condition buzzer is active till buzzer silence button is pressed.
Button Protection Parameter
There is no protection.
Temperature set value can not be changed.
Humidity set value can not be changed.
Temperature set value and Humidity set value can not be changed
Programming Mode Accessing Password
It is used for accessing to programming mode. It can be adjusted from 0 to 9999. If it is 0,
password is not entered for accessing to the parameters. When the password screen is not
set as "12" , If the user enters '12' in password screen
accessed and they can changed.
( Default = 60 )
Parameter ( Default = 0)
to maximum value of the device scale.
(Default = 0)
Parameter( Default = 0 )
)
value = 0, this parameter is not observed.
( Default = 0 )
( Default = 0 )
parameter.
(Default = 0)
is observed. In
and parameters are
12