Clean The Spray Tip; Transportation And Storage; Spray Tip Maintenance; Remove The Spray Tip - GreenWorks Pro PW18HYB Manual Del Operador

WARNING
If you do not use the machine
• Stop the machine.
• Turn the water supply off.
• Remove the battery pack.
• Pull the gun trigger to release the remaining pressure
from the machine.
• Lock the trigger safety button.
6 MAINTENANCE
WARNING
Before maintenance, make sure that you
• Stop the machine.
• Wait until all the moving parts stop.
• Disconnect the plug from the power source.
WARNING
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
WARNING
Replace the power cord by an approved service center.
6.1

SPRAY TIP MAINTENANCE

WARNING
Never point the spray wand at your face.
6.1.1

REMOVE THE SPRAY TIP

1. Pull back the quick-connect collar (27) on the spray wand
(4).
2. Remove the spray tip (26) from the spray wand (4).
English
6.1.2
1. Use a straight paper clip or cleaning tool (29) to clean the
2. Flush and clean the unwanted materials out of the spray
3. Install the clean spray tip (26) back into the spray wand
7
7.1
•
•
7.2
26
•
•
•
4
•
•
15

CLEAN THE SPRAY TIP

spray tip.
tip (26) with the garden hose (21).
(4).
TRANSPORTATION AND
STORAGE
WARNING
Disconnect the power cord and watter supply hose before

transportation and storage.

MOVE THE MACHINE
Point the spray wand in a safe direction.
Only hold the machine with the handgrip.
STORE THE MACHINE
WARNING
Make sure that the spray gun, the high pressure hose and the
pump are dry.
WARNING
Make sure the machine is out of the reach of children.
NOTE
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
Disconnect the garden hose from machine.
Wind the power cord and the high pressure hose.
Clean housing and the plastic components with a moist
and soft cloth.
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone number
(enter number here) for servicing instructions.
Store the machine in a dry, isolated and frost-free area.
EN
29
26