Ventilation Hose And Medutrigger - Weinmann MEDUMAT Easy CPR Descripción Del Aparato E Instrucciones

4.2 Ventilation hose and MEDUtrigger

3. Then loosen the screw connection to the
Connecting the new cylinder
1. First briefly open and close the valve of the new ox-
2. Screw the pressure reducer to the bottle valve
3. If appropriate, screw the pressure tube to the
4. Screw the other end of the pressure hose on to
60
50
40
30 CP R
20
10
0
1. Slide the MEDUtrigger onto the MEDUtrigger
cylinder.
ygen cylinder. This is to blow away any potential
particles of dirt.
Keep the valve opening away from the body,
making sure that neither yourself nor other per-
sons can be injured by escaping particles.
using the corrugated union nut. Tighten the
union nut hand-tight.
outlet of the pressure reducer using union nut G
3/8.
pressure gas connection on the
MEDUMAT Easy CPR if this has not yet been
done.
connection.
Note:
When the MEDUtrigger connector is pulled out,
it must be released from the socket from under-
neath by initially being pushed briefly in a verti-
cal direction. Make sure that you do not rotate
the MEDUtrigger connector when either
EN
Installation
19