Maintenance - Nippon Gases CS-300 OXIGAS-P/GN Intrucciones De Manejo Y Seguridad

7. MAINTENANCE

7.1. Protect the torch from damage (check visually at regular intervals).
7.2. Clean the torch at regular intervals to avoid presence of grease or dirtiness. When
necessary, clean the holes of the cutting nozzles with the cleaning needles supplied (art
Cod. 2305203.
7.3. Check that flexible hoses are in good condition & remove parts that are damaged.
7.4. Check that connections are secured with hose clamps that cannot hurt the hose by
excessive pressure (to avoid cutting of the hose).
7.5. Replace non return valves when gas flow is reduced & every time a gas back-flowing
has happened.
7.6. Check gas escapes with leak detecting fluid (NEVER WITH FLAME); change immediately
the damaged component.
ATTACHMENT FOR OXY-CUTTING CS-300, OXYGAS-P/GN
SPARE PARTS
EN
PT
EN
23