Kohler STERLING 6300 Serie Guia De Instalacion página 6

Wall Jamb
3. Locate the Wall Jambs
Position the wall jamb flat against the wall with the base of the jamb centered on the shower
threshold.
NOTE: Some filing may be required of the bottom edge of the wall jamb if your bath unit has rounded
corners.
Plumb the wall jamb into position using a level.
Temporarily secure the level position of the wall jamb with several pieces of masking tape.
Make a pencil mark at the four pre-drilled hole locations in the wall jamb.
Remove the masking tape, then remove the wall jamb to an out of the way place to prepare for
drilling of the four holes.
NOTE: When installing on ceramic tile, use a center punch to lightly "nick" the surface of the glaze. Tap
the center punch lightly with a hammer to avoid cracking the tile.
Slowly drill the marked hole location with a 5/16" drill bit. If drilling through ceramic tile, use a
masonry drill bit.
Insert a wall anchor into each hole.
Reposition the wall jamb over the installed wall anchors.
Secure the wall jamb loosely onto the wall with the four # 8-18 x 2" provided screws.
NOTE: Thoroughly clean and dry all dust, dirt, and grease from the bottom track and shower ledge
surfaces.
Repeat the procedure for the opposite wall jamb, taking care to make sure it is directly opposite the
first installed wall jamb.
1019156-2-H
Drill holes.
#8-18 x 2"
Wall Anchor
Press and hold legs together.
6
Wall
Jamb
Measure here.
Sterling