7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily injury,
NOT use power tools to assemble the blades. If
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on each
blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in one of
the hardware packs. Hold blade arm up to blade and align
holes. Insert 3 blade attachment screws (along with washers)
with fingers first and then tighten screws securely with a
Phillips screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers from fan motor
and set aside. Then, if applicable, remove plastic motor locks
from underside of motor and discard plastic motor locks
(save blade arm screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes and attach
blade arm with lock washers and blade arm screws. Before
securing screws permanently, repeat with remaining blade
arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Remove 3 screws from light kit fitter. Locate
BLACK (or BLUE) and WHITE wires in the
switch housing labeled LIGHT. Remove and
discard plastic that holds these 2 wires
together.
Next, locate WHITE and BLACK wires in light
kit fitter labeled LIGHT.
screw
canopy
DO
plastic
motor
lock
lock washers
white wire
white wire
page 6
hanging bracket
screw
canopy cover
motor housing
blade attachment
screws and washers
blade
blade arm
blade arm
screws
motor housing
switch
housing
black (or blue) wire
black wire
light kit fitter