Operating Display - simalube IMPULSE Manual Del Usuario Y Información Técnica

EN
8.
9a.
9b.

5. Operating display

After the simalube lubricator's start-up time, the IMPULSE will continuously be
supplied with lubricant and the device switches into normal operating mode, if the
"Time" mode has been selected in the app, the device switches to normal operat-
ing mode after the second pump stroke. The green LED flashes every 10 seconds
during the entire dispensing time. Errors are indicated by a blinking red LED or
are shown directly in the app. An error status is indicated for as long as the error
exists. If no LED is flashing, the device is not in operation, is faulty or the battery is
completely empty. Inspections are recommended once a week if a dispensing time
of 1 month is set, every 2–3 weeks for a dispensing time of 3 months and once a
month for a dispensing time of more than 3 months.
LED function display (next to the IMPULSE logo):
Green LEDs flash (every 10 seconds)
1× OK – normal operation
2× Start mode
(wait until simalube pumps lubricant)
Blue LEDs flash
(every 10 seconds)
9× Connected to phone
8. The simalube lubricator is then screwed onto the
IMPULSE which fixes the battery pack in place and
thus activates the device.
.
Important: The upper grey rim of the simalube should
be screwed flush into the IMPULSE housing.
9a. It is possible to connect the IMPULSE connect via
Bluetooth with the simatec app, which gives you
®
more control and information about your IMPULSE.
You can download the app from the Apple Store or
Google Play Store.
9b. The Bluetooth
marked with a Bluetooth
After registering the IMPULSE in the app, the fol-
lowing parameters must be set in the app: name,
lubricant type, size and runtime.
16
code is printed on the IMPULSE and
®
icon.
®
Red LEDs flash (every 10 seconds)
1× No lubricant – dispenser empty
2× Battery power low
3× System pressure too high (>10 bar)
4× Pump blocked
5× Max. number of pump strokes
reached.
IMPULSE