Metabo HPT SB 10V2 Instrucciones De Manejo página 5

PRECAUTIONS ON USING BELT SANDER
CAUTION
Prior to the sanding operation, make sure the material
you are going to sand.
If generation of harmful/ toxic dusts such as lead paint,
woods and metals is expected under the sanding
operation, make sure the dust bag or appropriate dust
extraction system is connected with dust outlet tightly.
SPECIFICATIONS
Model
Voltage (by areas)*
Power input*
No-load belt speed
Sanding belt size
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Endless sanding belt (Grain size: #80) ..........................1
(2) Dust bag .......................................................................1
Standard accessories are subject to change without notice.
OPTIONAL
(sold separately)
1. Endless sanding belts
Table1
Grain size
40
60
80
100
120
150
180
240
NOTE:
The endless sanding belt is sold in package of 10 belts of
the same type. When ordering, specify the grain type and
grain size desired.
2. Stationary Stand
When sanding small articles, use a stationary stand for
convenience.
Optional accessories are subject to change without notice.
SB10V2
(110V, 120V, 127V, 220V, 230V, 240V)
240 – 420 m/min
APPLICATIONS
○ Finish sanding and fi nish fl ooring of woodwork products.
○ Base polishing of wood-coated surfaces.
○ Finish sanding of metal surfaces.
○ Base polishing of metal-coated surfaces, rust removal, or
ACCESSORIES
○ Surface fi nishing of slate, concrete, and similar materials.
PRIOR TO OPERATION
1. Power source
Grain Type
AA, WA, CC
2. Power switch
AA, WA, CC
AA, WA, CC
AA, WA, CC
3. Extension cord
AA, WA, CC
AA, WA, CC
AA, WA, CC
4. Attach the sanding belt
AA, WA, CC
HOW TO HANDLE SANDING BELT
CAUTION:
1. How to attach sanding belt
(1) Pull lever with fi nger, idle pulley will then move backward.
Wear the dust mask additionally, if available.
Do not inhale or touch the harmful / toxic dusts generated
in sanding operation, the dust can endanger the health of
yourself and bystanders.
1020 W
100 × 610 mm
5.2 kg
paint removal prior to refi nishing.
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
Ensure that the power switch is in the OFF position. If the
plug is connected to a receptacle while the power switch
is in the ON position, the power tool will start operating
immediately, which could cause a serious accident.
When the work area is removed from the power source,
use an extension cord of suffi cient thickness an rated
capacity. The extension cord should be kept as short as
practicable.
For details, refer to the section on "Sanding Belt
Assembly".
Be sure to switch power OFF and disconnect the plug
from the receptacle to avoid serious trouble.
(Fig. 1)
English
SB10S2
420 m/min
5