Tools Required - Intex 28072 Manual Del Usuario

Estimated assembly time 30-60 minutes. (Note the assembly time is only approximate
and individual assembly experience may vary.)
TOOLS REQUIRED: One (1) Phillips screwdriver
One (1) pair of pliers or a small adjustable wrench
IMPORTANT: Do not fully tighten fasterners until last assembly operation.
1. SIDE A LEGS ASSEMBLY (refer to figures 1.1 through 1.2):
The pool ladder legs have the step mounting fixtures installed at the factory.
Slip the step (9) onto the mounting fixture, matching the direction of the arrow on the
back of the mounting fixture with the top of the step. Ensure the back of the step is
flush with the mounting fixture otherwise the step will be installed upside-down.
IMPORTANT: Ensure the J-shaped legs are pointing outwards before installing the
steps.
B1
A1
Push the step mounting pins (8) into the holes securing the step to the mounting
fixture.
2. SIDE B LEGS ASSEMBLY (refer to figures 2.1 through 2.2):
B2
A2
IMPORTANT: Push the step mounting pins (8) into the holes securing the step to
the mounting fixture. Make sure all pins are securely locked.
SAVE THESE INSTRUCTIONS
(289IO) 42" LADDER WITH REMOVABLE STEPS ENGLISH SIZE: 7.5" X 10.3" PANTONE 295U 05/27/2016
LADDER SETUP
1.1
2.1
B1
A1
8
B2
A2
8
English
289A
1.2
9
2.2
9
Page 5