Manual Wire Feeder Panel Connector Description - Cebora KINGSTAR 400 TS Manual De Instrucciones

BB - LED HOLD
This lights up automatically at the end of the welding process, displays AR and AS show the most recent measured
arc current and voltage values.
BD - JOB retrieval key
Press key BD to call up the JOB function (see section 7). They can be selected by turning knob AW
BC - LED JOB
This lights up when the JOB is selected
BE - LED Remote control
This lights up when a remote control is connected to connector E of the wire feeder (see section 3.8).
BG - LED Cooling unit
This lights up when the cooling unit is activated (see section 7.3.1)
BF - Wire Rewind key
When this key is pressed, the motor rewinds the wire by a few centimetres without any voltage and welding gas in
the torch.
BH - Wire Feed key
When this key is pressed, the motor feeds the wire, without any voltage and welding gas in the torch.
BL - Gas test key
When this key is pressed, the gas fl ows out for 30 seconds. If pressed again during gas fl ow, the fl ow stops.
BI - LED Quality control
This lights up when quality control is active (see section 7.3.6)
3�8

Manual wire feeder panel connector description

Pin Description
Start Digital input
1
2 Down-Volt Digital input for decreasing welding voltage
Down-Mot Digital input for decreasing motor speed
3
4 Arc-ON Clean contact (30 VDC, 125 VAC, 0.5 A max)
Arc-ON Clean contact (30 VDC, 125 VAC, 0.5 A max)
5
6 Up-Mot Digital input for increasing motor speed
Current Ref. Current reference potentiometric input
7
8 Mot_PP Push-Pull motor positive
Start Digital input
9
10 Up-Volt Digital input for increasing welding voltage
+ 5 VDC Potentiometer power supply
11
12 Rec_AN External control analogue recognition
Gnd Potentiometer input ground reference
13
14 NC
+ 12 VDC Insulated digital input reference
15
16 Rec_AN External control analogue recognition
Mot_PP Push-Pull motor negative
17
18 NC
NC
19
3301065/A
Wiring diagram
69/109