Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FAN GRILL ASSEMBLY
1. Unscrew the 4 x Grill Screws from the Motor Unit(the handle on the Rear
Grill should be on the top),align the Rear Grill on the Motor Unit, then screw
in the 4x Rear Grill Screws to secure it in place.
2. Remove the plastic sleeve on the Motor Shaft and install the Blade onto the
Motor Shaft by tightening the Blade Screw. Ensure that the flat surface of the
Motor Shaft is aligned with the Blade Screw.
3. Centre the Front Grill by aligning the central logo so it is horizontal and
parallel to the floor. Then, secure the Front and Rear Grills completely
together by snapping 5x Grill Clips into place. Lastly, tighten the Grill Locking
Screw at the bottom of the Rear Grill
OPERATING INSTRUCTIONS
Ensure voltage used corresponds with the voltage indicated.
Use the Switch Control to select the speeds: 0(off) and speeds I,II,III, is Slow,
1.
Middle, Fast.
Push down the Oscillation Knob to start oscillation. Pull it up to stop
2.
oscillation.
Loosen the Tilt-Lock Knob slightly to adjust the tilt angle of the fan head,
3.
then re-tighten.
4. To adjust height, loosen the Height-adjust Knob, lift or lower Inner Pole
to the desired height, and retighten
5) Never touch the blades with hand or any object!
CLEANING AND MAINTENANCE INSTRUCTIONS
To clean: Disconnect the power cord from the mains. Remove the Front Grill and
the blades carefully. Do not drop the blades! First use soft cloth with light soap
to clean off oil stains, then wipe thoroughly with dry cloth. Never use polish or
any corrosive liquid that will damage the paint, metal or plastic! Put back the
blades and lock the guard securely before use.
WARNING: Ensure that the fan is switched off from the supply mains before
removing the grill. After servicing, any safety device (including grilles and blades)
must be reinstalled or remounted as previously installed.
TECHNICAL SPECIFICATIONS
Power Supply: AC 220-240V ~ 50Hz
Power Consumption: 50W
NOTE: As a result of continual improvements, the design and specifications
of the product within may differ slightly to the unit illustrated on the
packaging.
Publicidad
Tabla de contenido
