Svan SVVE02160PR Manual De Instrucciones página 9

ASSEMBLY INSTRUCTIONS
BODY ASSEMBLY
1. Unscrew the Ring and Base Locking Screw from the Pole.
2. Insert the Pole through the hole in the center of the Stand Base, and twist into
position.
3. Turn the Base upside down with the Pole facing the floor and place the Base Weight
Support to the bottom of the Stand Base. Tighten the Base Weight Support to the Stand
base by the Ring and Base Locking Screw.
FAN HEAD ASSEMBLY
Neck Fixing Bolt and Knob – to fix the Motor Unit to the Inner Pole
Locating Screw – to limit the angle of tilt
Tilt Adjustment Knob – to adjust the tilt
1. Remove the Neck Fixing Bolt and Knob from the top of the Inner Pole.
2. Remove the Tilt Adjustment Knob from the neck of the Motor Unit; place the
neck over the Inner Pole with Locating Screw aligning with the slot on the side
of the pole. (See Figure 1)
3. Run the Neck Fixing Bolt through the neck of the Motor Unit and the Inner
Pole and tighten the Locating Screw leaving approximately 3mm gap under
the screw head. (See Figure 2)
4. Fix the Neck Fixing Knob to the Neck Fixing Bolt and fix the Tilt Adjustment
Knob to the neck of the Motor Unit. Now you can adjust the tilt of the Motor
Unit and secure it in position by tightening the Tilt Adjustment Knob.
(See Figure 3)