Homewerks 7148-01-AX Manual Del Usuario página 5

PREPARATION (Continued)
WARNING: RISK OF ELECTRIC SHOCK! Ensure the electricity to the wires you are working on
is shut off. Either remove the fuse or turn off the circuit breaker before removing the existing
bath fan or installing the new one.
Before removing your current ventilation fan, verify the wall switch box has the required wires necessary
for this installation. These wires are power (black) and neutral (white), as shown in the wiring diagram
below. If you do not see both of these wires, consult a licensed electrician.
Check area above installation location to be sure that wiring can run to the planned location and that
duct work can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere
with installation work.
You may need the help of a second person to install this fan; one person on the attic side and one on
the room side.
Installation may vary depending on how the previous bath fan was installed. Supplies necessary for
the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.
DIMENSIONS
Ceiling
Opening (L) Opening (W)
9-1/4 in.
IMPORTANT: ATTIC ACCESS IS REQUIRED FOR PROPER INSTALLATION.
WIRING
All wiring must be connected for full functionality. Do not use metal wall plate with switch.
Homewerks.com
Ceiling Ceiling
Opening (H)
9-1/4 in. 5-29/32 in.
Housing
Dimension (L)
9 in.
5
Housing Housing
Dimension (W) Dimension (H)
9 in. 5-25/32 in.