Specification - Multilaser explorer Manual Del Usuario

Install and Remove the Front Panel

Specification

General
Power Supply Requirement: 12V CC
Speaker Load Impedance: 4Ω
Max. Power Output: 40 W x 4CH
Tone Controls: 8dB (bass 100 Hz, treble 10 kHz)
Dimensions: approxx. 198 x 187 x 60 mm (D x W x H)
Mounting Dimensions: approx. 160 x 182 x 50 mm (D x W x H)
Weight: approx. 2,75 kg
DVD deck section
Disc and formats viewed: DVD, MPEG4, DIVX, VCD 1.0 / 2.0, MP3, WMA, CD, CD-R / RW
Video System: Auto / PAL / NTSC
Mounting Angle: 0 ~ 30 degree
Remove the front panel
Press REL button in the upper left corner, and then the front panel will
be folded down. When the front panel was turn down to a position of 450,
hold and slide the front panel to left, and the pull it out.
Install the front panel
Put notch A (shown as picture) onto shaft B, and then slightly press
into the right side.
multilaser
www.
51
.com.br